Search
Forum
Wiki
Images
Files
Member List
Help
08-26-2016, 05:43 PM
For folks making a mold, one idea I was wondering about is making the cover corner bits separate pieces, like this:
![[Image: normal_Top_Bit.png]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Top_Bit.png)
The thinking is that this could then be a "cap" that would cover the corner where the sides fit. One could then trim the sides to fit the space available, and then trim the corner to fit.
NOTE: the model is about 2" wider than the existing shell plans! That's around 3 Lego studs on each side!
The thinking is that this could then be a "cap" that would cover the corner where the sides fit. One could then trim the sides to fit the space available, and then trim the corner to fit.
NOTE: the model is about 2" wider than the existing shell plans! That's around 3 Lego studs on each side!