Most viewed - Files and Images for rebeldroids.net

Most viewed

1 views

Broken Magnet while assembling DMM (Dome Magnet Mount)1 viewsI was trying to figure out which side was North, and the test magnet flew out of my hands the last inch and sacrificed itself on the larger magnet. One bit went flying past my head 'cause I heard it hit the wall.

Lego BB-8 Dome Magnet Mount Cap Cover.1 viewsThis gets put on the Magnet Mount to mount the rest of the dome for it, and to keep the bearings and magnets where they belong. Not sure I trust it by itself to hold the magnets.

We used the Body Magnet Mount (BMM) to hold the magnets away from the wood1 views

The gap, holding them for temporary storage1 views

1 views

Same photo wider angle lens1 views

I think the toolbox droid is near this engine1 viewsfrom http://starwarsscreencaps.com/star-wars-episode-vii-force-awakens-2015/80/

Lego BB-8 Driving us around1 views He thinks this drive is on the "right" side.

Lego BB-8 Driving us around1 viewsBetter than Tesla autopilot? He thinks this drive is on the "right" side.

MCK-Y the Lego Mouse Droid and a Castle1 viewsLego Mouse Droid and Castle

1 views

Showing how corners line up1 views

Lego Greebles for H-015 Sentry Droid1 views

Lego Greeble instructions B for H-015 Sentry Droid1 views

Lego Greeble instructions D for H-015 Sentry Droid1 views

Lego Greeble instructions F for H-015 Sentry Droid1 views

Lego Greeble instructions H for H-015 Sentry Droid1 views

Lego Greeble instructions J for H-015 Sentry Droid1 views

Perhaps a filler top bit could work on the corners to adjust for sizes?1 viewsCorner top bit

The Lego Greeble Position WRT the Skiert on the Sentry Droid1 viewsThe Lego is recessed under the skirt. There is a solid row of bricks, and the smooth tiles on the bricks below that row are about flush with the edge of the skirt.

Test print of 3D Printed Antenna #21 viewsIf all you have is a hammer, everything looks like a nail. And we have a 3D printer and we don't have sheet styrene right now...

Wondering about extra lines in Fusion plans.1 viewsFor the one with the lines in the middle, it's a slot for the vertical parts to seat in. For the one with lines at the edge, it's supposed to be rounded off there.

Question about Rings for Fusion Generator1 viewsThe answer is that it's the top picture: One ring with two inner grooves/to put other bits.

Proposed Lettering of Fusion Parts1 views

Lara & Shawn working on H-015 Bottom Greebles1 views

Shawn's printed antenna on the Lego top1 views

3D printed H015 Antenna1 viewsFrom the 3D files in http://www.rebeldroids.net/gallery/thumbnails.php?album=63 - but apparently I posted those in the wrong spot!