06-01-2023, 01:03 PM
Rear supports #3Dprinted and screwed into place (last picture).
A detail I’d missed is that the legs on the mast base are not silver but a dark colour, possibly black, possibly blue…... So I masked them off and sprayed them up black for now.
The correct logic panel tops were printed, in my haste, I’d uploaded the older versions last week.
These, along with the other panels, I primed and sprayed them blue. They look great.
Test fitted them back on the body:
Did some more filling and sanding of the wood and it’s edges.
Marked and drilled the axle holes:
Then started to apply a coat of primer to the front half of the body.
Some more prep work to be done and need to buy some more primer spray paint.
Sent from my iPhone using Tapatalk
A detail I’d missed is that the legs on the mast base are not silver but a dark colour, possibly black, possibly blue…... So I masked them off and sprayed them up black for now.
The correct logic panel tops were printed, in my haste, I’d uploaded the older versions last week.
These, along with the other panels, I primed and sprayed them blue. They look great.
Test fitted them back on the body:
Did some more filling and sanding of the wood and it’s edges.
Marked and drilled the axle holes:
Then started to apply a coat of primer to the front half of the body.
Some more prep work to be done and need to buy some more primer spray paint.
Sent from my iPhone using Tapatalk