Shawn & Lara need a Toolbox... Droid?

[kresty]

The idea has been to have the droid done before BrickCon next weekend (always 1st weekend in October).  This may be tough.  

Managed to get the hard part of the top, tomorrow Lara will get the bottom recess bit - We chose to split it about where Lee's real droid's top came off.

Toolbox Top 3/4 Way
Work area... Lots of bricks.

Toolbox Top 3/4 Way
Getting closer with the toolbox droid top - have most of the hard part done.

Toolbox Top 3/4 Way
The green is the printed brick to get the angles right and for strength.

At the bottom of the printed brick are a bunch of little holes. That's at an angle and the intent is for the holes to line up with holes in the top printed brick of the body. Then we'll pin them in with Lego lightsabers (or similar diameter poles).

Toolbox Top 3/4 Way
Different Angle.  The green in the previous will be laminated like this, probably tomorrow.