Search
Forum
Wiki
Images
Files
Member List
Help
05-15-2018, 09:57 PM
Well, some of it's been printed. The other side is on the printer now... The bearings fit pretty well, though one surprised me by cracking the housing on one side - still plenty tough, but I think I'll reprint it.
Not sure if the layers aren't sticking quite right or what. There was a little bump I missed sanding off and apparently that was enough that pressing in the bearing was just a little too much. (I can't pull off the cracked top, so it can't be that bad).
The first one I didn't get quite all the supports out and the bearing was visibly angled a little. My screw holes allow for some movement, but hopefully it won't be too much.
Eagerly awaiting the rest of the parts being finished tomorrow... Which is when my couplers should also arrive. We'd like to show off the droid Saturday evening if we can...
Not sure if the layers aren't sticking quite right or what. There was a little bump I missed sanding off and apparently that was enough that pressing in the bearing was just a little too much. (I can't pull off the cracked top, so it can't be that bad).
The first one I didn't get quite all the supports out and the bearing was visibly angled a little. My screw holes allow for some movement, but hopefully it won't be too much.
![[Image: normal_WP_20180515_22_27_07_Pro_281920x143929.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_WP_20180515_22_27_07_Pro_281920x143929.jpg)
Eagerly awaiting the rest of the parts being finished tomorrow... Which is when my couplers should also arrive. We'd like to show off the droid Saturday evening if we can...