Rebel Droids.net › Droid Discussions › Build logs v
Kresty working on Fusion Power Generator

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Kresty working on Fusion Power Generator
kresty Offline
Administrator
*******
Posts: 1,846
Threads: 230
Joined: Aug 2014
#18
03-25-2017, 09:54 PM
I stuck some modified top files in the 3D files section.

[Image: thumb_Modified_3D_Printed_Files_28Kresty_s29.png]

I did a few things:
  • Stretched the "flat" part at the bottom a little
  • added a lip to go inside the center of the styrene circle.
  • added a lip for the center cap.
  • added a lip to go under the next section.
[Image: normal_Modified_3D_Printed_Files_28Kresty_s29.png]

I haven't actually tested these parts yet, I should have them printed in a week or two.
Website
Reply


Messages In This Thread
RE: Kresty working on Fusion Power Generator - by kresty - 03-25-2017, 09:54 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)