Search
Forum
Wiki
Images
Files
Member List
Help
01-25-2017, 09:06 PM
So these are the files I used to cut the 1/16" laser cut parts:
The cut lines are set to 0.0096pt and RGB Black 0 0 0 - Our Universal uses the color to key off of, the Epilog uses the narrow line width to key off of. I could send the PDF files to either.
As mentioned above, this was my first attempt cutting styrene and the results were a little inconsistent, not quite cutting through in places, and burning too much in others.
![[Image: normal_Laser_24x18_Alternate_Flat_Pack.png]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Laser_24x18_Alternate_Flat_Pack.png)
The cut lines are set to 0.0096pt and RGB Black 0 0 0 - Our Universal uses the color to key off of, the Epilog uses the narrow line width to key off of. I could send the PDF files to either.
As mentioned above, this was my first attempt cutting styrene and the results were a little inconsistent, not quite cutting through in places, and burning too much in others.