Search
Forum
Wiki
Images
Files
Member List
Help
03-10-2017, 10:19 AM
So, the beta "laser cut parts" plans are updated. I included the 1/8" parts, as well as outlines for the translucent panels.
Note that I still haven't assembled them, so I'm not sure how well they work (I think they should be "good enough"). Mostly I'm concerned about my kerf being different than Savage's original plans.
Should you choose to print them, I'd seriously consider something else besides etching the notches on the notched parts. Particularly at the orientation I used they took forever just to etch that notch on each of those 3 sheets.
Alternate methods would be to leave out the notch and add another inner ring to provide a place to affix the vertical parts.
![[Image: thumb_Laser_24x18_Alternate_Flat_Pack.png]](http://www.rebeldroids.net/gallery/albums/userpics/10017/thumb_Laser_24x18_Alternate_Flat_Pack.png)
Note that I still haven't assembled them, so I'm not sure how well they work (I think they should be "good enough"). Mostly I'm concerned about my kerf being different than Savage's original plans.
Should you choose to print them, I'd seriously consider something else besides etching the notches on the notched parts. Particularly at the orientation I used they took forever just to etch that notch on each of those 3 sheets.
Alternate methods would be to leave out the notch and add another inner ring to provide a place to affix the vertical parts.