MSE-6 Build notes

[Roger Booth]

Some folks use hub extenders to get skinner wheels to the right widths.

These are the wheels I've bought, did quite a bit of searching but couldn't find anything better in the UK.
(If you can get in the UK can I have the link?)

They are World GT wheels, I think they are a pretty good match and will certainly do the job.

   

   

I have adapters so the wheels fit the chassis and I'm happy with the widths I'm getting.
I've only offered the bits together but the back wheels do stick out from the back wheel arch and front wheels are level or a little inside of the front wheel arch. 

What sort of angle should the upper shell sit at, it looks as though the original is sitting lower on the front axle?
Are there any measurements for the clearances between shell and road for the back and front?
This will help with the chassis build.