Markus' H015 from cardboard

[Markus]

It's time to start my H015 build!
Based on my measurements posted in the other thread, I created some plans for building a H015 droid from cardboard. I am using thick corrugated cardboard which one can get for free in large sheets e.g. at Sam's Club. The original size (with a baseplate of 70cm x 70cm) is too large for my purposes, so I decided on a size of 70% of the original. This works well together with my mouse droid MSE-6c which was built at 90% of the size of the original, and my astromech droid R3-B9 which is approx. 50% of R2-D2's size.
With this in mind, I have created the following plans. These plans are not exactly up to scale. So, one can not simply enlarge these, but has to redraw everything on the cardboard. The head and the rest of the body are each made out of two pieces. These two pieces are both glued to a connecting ring which is made out of one layer of cardboard for the headpieces, and two layers of cardboard for the body pieces.

Here are the plans for the two head pieces,
   
for the upper part of the body,
    ,
for the lower part of the body,
    ,
 and for the connecting rings.