11-08-2019, 04:52 AM
(This post was last modified: 11-08-2019, 04:53 AM by James-Rice.)
Yeah... It would be useful. I know I'm doing it in a material that's intrinsically to thin but it doesn't help.
Personally I wonder if there should be a version where there is only one of each component. It would be far easier for the template to be used more than once than having loads of bit, that said my printer can't print on card so I'm at a disadvantage.
Personally I wonder if there should be a version where there is only one of each component. It would be far easier for the template to be used more than once than having loads of bit, that said my printer can't print on card so I'm at a disadvantage.