Shawn & Lara need a Toolbox... Droid?

[kresty]

Oops, there are 22 link/tread bits on each track, not 20.  Original pix has 4 curving around each end and 7 on the top/bottom flat sections.  So that's 44 links, not 40.  And somehow I missed a x2 - I have 2 ties to print between each tread.  So instead of being over 1/2way done with the print, I'm barely 1/3 of the way done.

I sped up the print speed to 2200mm/min - so far it looks like it's doing OK.  Also printing 2 up (was doing one).  So ~2/hour instead of 1/45 min?

Also figured I may as well use more red, so I'm now running both printers.  (I wanted a little red, but if I need 2x the parts, then 2x the red is the same proportion).