Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Kresty Training Remote
#7
Some of the bits that attach to the outside have printed. I'm not trying to print them all at once because I want to avoid supports if possible and there are lots of little tiny sticks.

[Image: normal_WP_20170420_22_41_07_Rich_LI_281920x111629.jpg]
[Image: normal_WP_20170420_22_49_54_Rich_LI_281920x119529.jpg]

The gunports and tiny tank wheels did great. The brackets without the raft did well as well - better than the attempt with a raft. Large tank wheels aren't perfect, but can probably clean.

Some of these clearly need work:

* Equator bandaid is totally bizarre - that could be a print driver problem, and that's being looked at. Might try printing on their sides.
* Commander's hatches got really muddy on the top detail bits. I'm not sure if that's the slicer or what. I might try on a different printer. &/or make the model parts thicker.
* The wheel rims are "OK", but many of the lug nuts got lost, and I'm a little disappointed they aren't cleaner. I might see if I can improve those as well.

Well, getting there...
Reply


Messages In This Thread
Kresty Training Remote - by kresty - 03-16-2017, 01:36 PM
RE: Kresty Training Remote - by kresty - 03-17-2017, 11:58 AM
RE: Kresty Training Remote - by kresty - 03-17-2017, 12:01 PM
RE: Kresty Training Remote - by kresty - 03-17-2017, 08:23 PM
RE: Kresty Training Remote - by kresty - 04-07-2017, 07:13 PM
RE: Kresty Training Remote - by kresty - 04-10-2017, 10:10 PM
RE: Kresty Training Remote - by kresty - 04-20-2017, 10:07 PM
RE: Kresty Training Remote - by kresty - 04-28-2017, 11:10 PM
RE: Kresty Training Remote - by kresty - 04-29-2017, 05:59 PM
RE: Kresty Training Remote - by kresty - 06-11-2017, 05:13 PM
RE: Kresty Training Remote - by kresty - 06-17-2017, 07:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)