Fusion Generator Plans

[kresty]

V3 version of Kresty's laser cut flat pack... Several changes:

• Got rid of the optional taller/lower version. C Band and D Ring are removed for the pointy bottomed (more screen accurate) version.
  
• That means fewer sheets! All the 1.5mm (3/16") parts are on one sheet.
  
• Added tabs/slots for the window panel/translucent panel/M ring (removing the notches, which was hard)
  
• Added mount holes on the M ring for the T hose fittings. (I didn't do the same on the lower parts because I'm not sure the bottom bands can always be aligned well).
  
• Centered the K-ring tabs, which had been a little off.
  
• Included the part alignment guide templates.
  
• Added "alt lower diffuser" - instead of 2 parts it's only one part that's a bit short, however the gap can be positioned at one of the opaque walls of the grill.
  

V3 Alternate Plat Pack Files intended for 18x24 Laser Cutter