Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fusion Generator Plans
#4
So, I added the beta "laser cut parts" plans based on Savage's CnC plans.

(Laser parts don't need gaps between them and laser cutters tend to have a much smaller bed than Savage's CnC)


Note that I still haven't assembled them, so I'm not sure how well they work (I think they should be "good enough").  Mostly I'm concerned about my kerf being different than Savage's original plans.

Should you choose to print them, I'd seriously consider something else besides etching the notches on the notched parts.  Particularly at the orientation I used they took forever just to etch that notch on each of those 3 sheets.  

Alternate methods would be to leave out the notch and add another inner ring to provide a place to affix the vertical parts.
Reply


Messages In This Thread
Fusion Generator Plans - by savagecreature - 01-21-2017, 09:17 AM
RE: Fusion Generator Plans - by kresty - 01-21-2017, 11:47 AM
RE: Fusion Generator Plans - by kresty - 01-21-2017, 11:47 AM
RE: Fusion Generator Plans - by kresty - 03-10-2017, 10:21 AM
RE: Fusion Generator Plans - by Ericgryn - 07-15-2017, 08:00 PM
RE: Fusion Generator Plans - by kresty - 07-15-2017, 10:28 PM
RE: Fusion Generator Plans - by savagecreature - 07-16-2017, 09:06 AM
RE: Fusion Generator Plans - by kresty - 08-15-2017, 12:53 AM
RE: Fusion Generator Plans - by kresty - 08-22-2017, 12:16 PM
RE: Fusion Generator Plans - by kresty - 08-30-2017, 12:04 AM
RE: Fusion Generator Plans - by kresty - 11-26-2017, 12:15 PM
RE: Fusion Generator Plans - by kresty - 12-19-2017, 11:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)