02-17-2023, 06:12 PM
(This post was last modified: 02-20-2023, 09:35 PM by Dyne.
Edit Reason: Replace tapatalk image
)
I tried heat bending the warped part. That helped a little and it works for now, but I'll likely reprint that section before i put time into finishing the new parts. The other 3 side panels were all printed successfully.
We arrived at the con and I drove the droid for several hours today, until his battery (and mine) started running low. One belt came off when I drove too fast, but I was able to just pop it back in place on the pulley.
The side plates are working great. No issues with the mounting system that aren't due to the warping or to the rear roller axle being slightly too long.
We arrived at the con and I drove the droid for several hours today, until his battery (and mine) started running low. One belt came off when I drove too fast, but I was able to just pop it back in place on the pulley.
The side plates are working great. No issues with the mounting system that aren't due to the warping or to the rear roller axle being slightly too long.
![[Image: 20230217_150629-smaller.jpg]](https://www.niflheim.net/droidbuilding/images/LD-F1/20230217_150629-smaller.jpg)