11-20-2022, 02:50 AM
Set the works printer to print most of the mast sections over the weekend. I say most as the filament looked a bit low, thankfully it has a runout sensor, so hopefully there was enough.
Previous to this, I had drawn up and printed off a cap for the mast, as well as a template to notch out the inner support tube, more later on this. I’m hoping this helps with rigidity.
Sent from my iPhone using Tapatalk
Previous to this, I had drawn up and printed off a cap for the mast, as well as a template to notch out the inner support tube, more later on this. I’m hoping this helps with rigidity.
Sent from my iPhone using Tapatalk