Search
Forum
Wiki
Images
Files
Member List
Help
09-27-2019, 10:28 PM
The idea has been to have the droid done before BrickCon next weekend (always 1st weekend in October). This may be tough.
Managed to get the hard part of the top, tomorrow Lara will get the bottom recess bit - We chose to split it about where Lee's real droid's top came off.
At the bottom of the printed brick are a bunch of little holes. That's at an angle and the intent is for the holes to line up with holes in the top printed brick of the body. Then we'll pin them in with Lego lightsabers (or similar diameter poles).
![[Image: normal_Toolbox_Droid_Top_Getting_There_28329.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Toolbox_Droid_Top_Getting_There_28329.jpg)
Toolbox Top 3/4 Way
Different Angle. The green in the previous will be laminated like this, probably tomorrow.
Managed to get the hard part of the top, tomorrow Lara will get the bottom recess bit - We chose to split it about where Lee's real droid's top came off.
![[Image: normal_Toolbox_Droid_Top_Getting_There_28629.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Toolbox_Droid_Top_Getting_There_28629.jpg)
![[Image: normal_Toolbox_Droid_Top_Getting_There_28729.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Toolbox_Droid_Top_Getting_There_28729.jpg)
![[Image: normal_Toolbox_Droid_Top_Getting_There_28429.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Toolbox_Droid_Top_Getting_There_28429.jpg)
At the bottom of the printed brick are a bunch of little holes. That's at an angle and the intent is for the holes to line up with holes in the top printed brick of the body. Then we'll pin them in with Lego lightsabers (or similar diameter poles).
Toolbox Top 3/4 Way
Different Angle. The green in the previous will be laminated like this, probably tomorrow.