Gareth’s Fully working D-O build

[Envisaged]

Ok so long TPU print was semi successful, defects at the top due to segments moving to much whilst being extruded, may try in flexible PLA to see if I get a better result.



Also been working on the side panels but has been slow going as I have a trapped ulnar nerve, leaving my left hand weak and my ring and pinky finger numb. So making sanding very difficult, but at least the power on / off switch fits and will be hidden behind the circular panel, that also hides the mounting bolts. This side will also attach with magnets so the whole panel and the hub plate will come off in one piece to give access to the guts.





D-O or D-O not, there is no try.