Ross' H015 Build

[r_saggio]

For the LED's, I ran a separate arduino nano for the LED control.  For some reason, trying to run the LED's off the main arduino with the motor controller shiled just drain the power away from the motors and bluetooth reciever.  A separate system for the lighting is no different then what's in my R2-Q2. For the body, I didn't want it to look like foam board. So, I puttied and sanded the corners, put 2 coats of Rustoleum primer with filler, sanded that and then put a coat of white Plasti Dip Spray over the whole body before spraying the whole thing white. Other then the edges along the bottom, you can't tell what it was made of. Most of the people at R2LA thought I made it out of polystyrene sheet.