07-21-2018, 01:01 PM
So I rigged up a strip of neopixels and printed a circular frame to attach them to.
Next I got an overhead light lens and cut some strips with the dremel(messy!!!)
3d printed some little corner guides to get the angles right.
... and this is why try, the lens is to close. I am reprinting the ring. I am backing the lens off by about 3 inches so the lights diffuse. I'll post an updated video later this weekend.
Next I got an overhead light lens and cut some strips with the dremel(messy!!!)
3d printed some little corner guides to get the angles right.
... and this is why try, the lens is to close. I am reprinting the ring. I am backing the lens off by about 3 inches so the lights diffuse. I'll post an updated video later this weekend.