Search
Forum
Wiki
Images
Files
Member List
Help
06-18-2018, 06:43 PM
Printed the front half of the body...
The inside is stringier than I'd like, particularly near the top. Not sure if the print speed was too high or it wasn't hot enough or what. Other printers I've used would've done that angle... Though this is larger diameter than I typically do.
The back half is now on the printer, along with a couple of the other remaining parts.
![[Image: normal_DRK-1_Front_Body_Hemisphere_28229.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_DRK-1_Front_Body_Hemisphere_28229.jpg)
The inside is stringier than I'd like, particularly near the top. Not sure if the print speed was too high or it wasn't hot enough or what. Other printers I've used would've done that angle... Though this is larger diameter than I typically do.
![[Image: normal_DRK-1_Front_Body_Hemisphere_28129.jpg]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_DRK-1_Front_Body_Hemisphere_28129.jpg)
The back half is now on the printer, along with a couple of the other remaining parts.