06-15-2018, 08:26 PM
I was just expecting something smaller for the central sphere.
P.S.: Sorry about the sudden radio silence. I started printing the front body piece, and started having issues I'd never seen before. It took 3 days of diagnosing the problem to figure out that my heatsink cooling fan had died, and heat creep was causing filament in my PTFE tube to melt, and then solidify, causing jams even though my calibration prints were printing fine. The replacement parts showed up yesterday, but I'm not going to have a chance to install them until some time next week, and then I'm going to have to re-level.
P.S.: Sorry about the sudden radio silence. I started printing the front body piece, and started having issues I'd never seen before. It took 3 days of diagnosing the problem to figure out that my heatsink cooling fan had died, and heat creep was causing filament in my PTFE tube to melt, and then solidify, causing jams even though my calibration prints were printing fine. The replacement parts showed up yesterday, but I'm not going to have a chance to install them until some time next week, and then I'm going to have to re-level.