Shawn's Printed DRK-1

[kresty]

unfortunately it's going to take a fair amount of work for me to fix that. I'll try to do another version with a more printer friendly lip on it in the next day or so and get it out to you.

Thanks for the updated file!


That's exactly what I meant, though I confess it took me like 2 minutes in 3D Builder to chop off the rounded edge.  I hope it wasn't too painful.  I think yours is better though, retains more of the lip.

Fingers crossed I'll try to start the front half today.  Yesterday I learned that the Z18 doesn't like NTFS formatted USB sticks (duh), and then later that I have to *wait* after saving from Simplify 3D because it does it in two steps and converting the gcode to a z18 factory file takes a while.  So I need to be more patient.