Shawn's Printed DRK-1

[kresty]

Here're the first 6 parts I printed.  Missing opposite corners (right rear, front left).  Tennis ball for scale.

A couple more photos - I tried using these for scale, but Savage objected to using our cat for scale, hence the previous tennis ball.

Cat messes up the scale

Thanks Savage!

The plan is to us CA to attach these together, then fill gaps with putty.  

I was able to print these 2-up on the XYZ Printer, but they'll only go 1 at a time on the FlashForge/Replicator clones - Given the print time that might be *way* saner anyway!

Printed at 0.2mm layer height with no support.  

One pair of the middle sections sticks out a bit, the overhang isn't as pretty as it could be since I didn't use support.  Should be fine with putty & sanding though.