02-12-2018, 10:47 PM
Having trouble getting a round peg to fit in a square hole. (Well, a D peg)
1/4" square hole, 6mm D shaft (flat spot comes in 0.6mm). I printed some shims to jam into the gap (really only the flat of the D and the corners), but they broke off pretty quick. Got some video, but when we tried to play with it again one wheel wasn't moving at all.
1/4" square hole, 6mm D shaft (flat spot comes in 0.6mm). I printed some shims to jam into the gap (really only the flat of the D and the corners), but they broke off pretty quick. Got some video, but when we tried to play with it again one wheel wasn't moving at all.