MSE Flat Pack Laser Ready Plans?

[Lumpy]

Awesome! 

I have access to another laser that is 24"x 36" as well but I was thinking to chop that part in half.
Yes I'm thinking of using a mixture of materials, styrene and baltic birch to start and layering if needed.
Probably do some resin/fiberglass support on the inside.

Any help is appreciated!

Kris

Cool, I'll try to get time to post something.  I guess in both formats (is vector PDF OK?)


I was toying with whether to add a few alignment tabs to help fit the sides or leave the edges straight (either way is going to need a little plastic putty or something to finish the edges since they're not 90 degree angles).

.dxf .svg vector .pdf It needs to be editable so we can change the line colors for the laser. For Trotec red (RGB 255, 0 , 0) is cut.

Cheers!