MSE Flat Pack Laser Ready Plans?

[kresty]

Awesome! 

I have access to another laser that is 24"x 36" as well but I was thinking to chop that part in half.
Yes I'm thinking of using a mixture of materials, styrene and baltic birch to start and layering if needed.
Probably do some resin/fiberglass support on the inside.

Any help is appreciated!

Kris

Cool, I'll try to get time to post something. I guess in both formats (is vector PDF OK?)


I was toying with whether to add a few alignment tabs to help fit the sides or leave the edges straight (either way is going to need a little plastic putty or something to finish the edges since they're not 90 degree angles).