Search
Forum
Wiki
Images
Files
Member List
Help
08-15-2017, 09:36 AM
This figure shows the difference in scale between the original mis-scaled PDFs (red) and the correctly scaled versions (black):
![[Image: normal_Bad_Sizes.png]](http://www.rebeldroids.net/gallery/albums/userpics/10017/normal_Bad_Sizes.png)
I'm trying to figure out how I'm going to "fix" my parts. Sheet 1 is really close, probably within the kerf of the laser. Sheet 0 isn't too bad either, just a little big - and on parts that wrap, those might be easy to trim.
So, I think I'm going to try only recutting the parts from the last sheet, Sheet 2. I'm wondering if I can re-use the little stand-off at least? Of course there are only 6 of those so maybe I should just recut them. In addition to the parts on these sheets, I also cut the fins for the top (vs 3D printing them), however I started with the 3D model so those should be OK.
I'm trying to figure out how I'm going to "fix" my parts. Sheet 1 is really close, probably within the kerf of the laser. Sheet 0 isn't too bad either, just a little big - and on parts that wrap, those might be easy to trim.
So, I think I'm going to try only recutting the parts from the last sheet, Sheet 2. I'm wondering if I can re-use the little stand-off at least? Of course there are only 6 of those so maybe I should just recut them. In addition to the parts on these sheets, I also cut the fins for the top (vs 3D printing them), however I started with the 3D model so those should be OK.