01-21-2017, 07:17 PM
Next question
My laser cutter software is going to try to cut all the lines, but these parts seem to have inner lines.
Are those where the other parts attach or something? I'm pretty sure I'd end up with 2 parts for the top one and a too-skinny part for the bottom one. (That's sheet 02_flatPieceLayout)
My laser cutter software is going to try to cut all the lines, but these parts seem to have inner lines.
Are those where the other parts attach or something? I'm pretty sure I'd end up with 2 parts for the top one and a too-skinny part for the bottom one. (That's sheet 02_flatPieceLayout)