Savage's Fusion Generator

[baptizer]

wow, looking good!!!

[kresty]

The whole time I was assembling this section of the base I was lamenting that there were no alignment holes or indications for placement of the geeblies that would later be attached to the base.  One of the primary reasons we use CnCs is for their precision, and the CnC will put the parts in the correct place better than we can with a ruler later. That's an addition to the plans I'll have to add soon.

After working on mine, I'm not sure that'd be much easier.  I glued the bands around without having to worry about where exactly the bands started and stopped.  If there were alignment holes on them, then I'd have to make sure the bands were positioned exactly at this step.

Additionally I had to trim a bit of one end, particularly on the first layer of the double layer stuff.

Maybe I'll change my mind when I get far enough along to try to figure out how to attach those bits